Why Replace 100% of Your Roof ... When Only
10% Is The Problem?
"For When It's Not A
New Roof You Need, But A Better Roof!"
METAL ROOF
UPGRADE
System 1000
System
1000 installs a complete, seamless 100% rubber system on metal roofs. Its
light weight, and attention to reinforcement that includes every seam and
fastener, enables total sealing without added weight load stress or punctures.
Topps' totally waterless compounds ensure that no rust can occur and
eliminates damage from bird excrement and most other atmospheric chemicals
that contribute to premature roof breakdown. All fasteners and seams are
systematically reinforced with either the SeamGuard™ or RivetGuard™ spray-on
compounds, further assuring an effective seal against leaks and corrosion
after completion of the TOPPS SEAL™ coating system.
Cleaning
RustArrestor™ is applied using a plastic
pump-up sprayer to any rust 1 day before power wash. Power washing
afterwards readies the surface for installation.
Reinforcing
Seam and fastener sealing may be done by spray using a (Graco or similar)
0.635 reverse-a-clean tip (no tip and low pressure for fasteners) using
SeamGuard or RivetGuard, or manually. Extra thickness is built where metal meets. Apply
2nd coat to all seams so joint disappears. Flashing grade
Polyprene™ is installed to seal flashings and gaps to 3/16". Reinforce all
gap repairs and critical areas by installing PolyCore™ membrane nap
(fuzzy) side down into Polyprene.
Finishing
The seamless Topps Seal™ rubber
coating is installed in 2 layers using a 0.631 tip or
roofing brush. Apply in a smooth and even fashion. Allow 24 hours between
coats. Base Coat™ may be used for the 1st coat on white jobs. Colored
roofs require 2 applications of the Topps Seal for best finish. After
allowing two weeks to dry, walk entire roof surface and add additional
material where needed.
